This is my 3=1 challenge. This was alot of fun and I have another that you will see in the photos below that I haven't finished yet. But this one is one that I made into a card:
flowersThis was so much fun Ann and I can see why AI are used.....I used 3 distress reinkers and they were so much fun to blend and play with on the glossy CS----BUT they took FOREVER to dry---I kind of hit them a little with a heat gun then just left them over night and didn't check on them until the next evening and by then 99% of it was dry--there was only two or three tiny spots that I had to get the heat gun on them.
I added the Liquidtec ink last and where I dropped and pulled it into the reinkers, it dried that night and parts alot sooner--just minutes! So I am going to try this again just using my Liquidtex inks and if AI are anything like this, I am definitely getting them! lol!
The photos below are: "begin 3in1" is what the piece looked like before I cut it in half and embossed.
"irid white" was what the pieces looked like after I used what was called "Iridescence White" paint (I didn't think I had white paint at the time), but I thought it looked silver more than anything and plus it was really hard to see without shinning light on it---but it was pretty too though. "White paint" is after I used a "Creme White" paint I found on them over the iridescence white paint.
Thank you Ann for a fun challenge !!